DIY Stamped Brass Keychain

I’ve always wanted to work with a metal in a more creative way. Last year, I finally splurged and bought a metal stamp set: the alphabet letters, steel bench block, and leather sand pad (which helps keep the noise level to a minimum – stamping metal can be loud!) added up to around $60. Since then, these supplies have opened up a whole new world of experimentation: custom jewelry, hand-stamped leather goods, and these totally custom, totally easy stamped brass key tags.

This project is an easy introduction to working with your metal stamp set, and the end result is a gorgeous brass tag with any word or phrase you can think of (that fits, of course). Make a few and switch up your keychain to suit your mood, or give some away as small gifts or party favors. Let’s get started!

You will need:

  • Paper
  • Pencil
  • Scissors
  • Inkpad
  • Masking tape
  • Hammer
  • 6mm alphabet metal stamps
  • Steel bench block
  • 1 1/2 or 2 inch blank brass tag
  • Key ring or ball chain

Optional:

  • Tassel
  • Leather sand pad (to muffle sound)

Step 1: Choose a design

Brainstorm what you want your keychain to say. Once you’ve decided on a word or phrase, you’ll want to test it out on paper before committing to brass. To test, stamp the word(s) on paper using your ink pad. Cut around each word.

Step 2: Center your design

Trace your tag and arrange your paper phrase so it’s centered on the tracing. If it fits, move on to step three. If it doesn’t, select another phrase and test again.

Step 3: Secure your tag

Place the metal tag on top of your steel block. Use masking tape to fix the tag to your block so it doesn’t wiggle around while you’re stamping. The tape will also help you line up your letters evenly as if you were about to write on lined paper.

Step 4: Start stamping

Take your first letter stamp and place it on the tag, using your initial paper design as a visual guide. While holding the stamp, rest your pinky and index finger on the block for stability. When you’re ready, hit the top of the stamp with a hammer. (Tip: think of it as a solid golf swing – you can only hit the stamp once, so put some gusto into it!) Continue stamping the rest of the letters.

Step 5: Keep stamping

If you have several lines of text, unpeel the tape and reuse it as a guide for your other lines. Stamp your next word(s), continuing to use your paper design for visual reference. Next steps ➜

 

DIY created by Clare McGibbon and edited by Aleksa Brown for Etsy.com


Share this post


Leave a comment

Note, comments must be approved before they are published